Very dark green, glossy leaves
Days after a feed increase; often with clawing and soft, leafy growth..
- Also called
- leaves too dark
- deep green leaves
- dark shiny leaves
- blue green leaves
Likely causes, most likely first
Ranked for this sign on its own. Your stage, medium and readings change the order, so run the checker for your plant.
PossibleNutrient burn (feed too strong)
Fix: Drop input EC by 0.3-0.5 mS/cm (or to about two-thirds strength); seedlings and clones need 0.4-1.0 mS/cm. Soil with pre-loaded nutrients usually needs plain pH-adjusted water for the first 2-4 weeks. If runoff is far above input, do a root-zone flush (see salt build-up).
Recovery: No new tip burn on leaves that open after the change, within 5-7 days; burnt tips stay.
How to confirm it
- Measure runoff EC against input EC. Water to 10-20% runoff, collect the runoff in a clean cup and measure EC of both with a calibrated meter (1.413 mS/cm standard). Runoff more than ~0.5 mS/cm above input means salt build-up; well below input means the plant is hungry or you are over-leaching. In hydro, compare reservoir EC with the EC you mixed.
- Pour-through extraction for container pH and EC. Water normally, wait 30 minutes to 2 hours, pour enough pH-adjusted water on top to collect about 50 mL of leachate (roughly 75 mL for a 15 cm pot, 150 mL for a 4 L pot, 350 mL for 11 L), and measure pH and EC of that 50 mL. Less disruptive than full runoff and more repeatable.
PossibleToo much nitrogen
Fix: Cut feed N by 20-30% (or the whole feed EC by ~0.3-0.5 mS/cm); for a heavy overdose in containers, run a root-zone flush with pH-adjusted, quarter-strength feed to 20-30% runoff. In flower, taper N while keeping P, K, Ca, Mg, S and micros fed.
Recovery: New leaves come in lighter green and flat within 5-7 days; clawed leaves relax partly.
How to confirm it
- Measure runoff EC against input EC. Water to 10-20% runoff, collect the runoff in a clean cup and measure EC of both with a calibrated meter (1.413 mS/cm standard). Runoff more than ~0.5 mS/cm above input means salt build-up; well below input means the plant is hungry or you are over-leaching. In hydro, compare reservoir EC with the EC you mixed.
- Lift the pot and check moisture at depth. Lift the pot right after a full watering to learn its wet weight, then lift before each watering. Water when it is clearly lighter (about half the added water gone). Push a finger or a moisture probe 5 cm (2 in) down. Heavy for 3-4+ days with droop: overwatering. Very light with limp papery leaves: thirst.
Less likelyCal-Mag overuse (excess calcium and nitrogen)
Fix: On hard tap water with a complete base feed, stop the Cal-Mag supplement; it adds N and pushes K and Mg out of balance. Use it only for RO or soft water and unbuffered coco. LEDs do not create a Cal-Mag need.
Recovery: K and Mg symptoms stop spreading within 7-10 days.
How to confirm it
- Get a water report (or test your water). Ask your water utility for the annual report or test well water: alkalinity (mg/L CaCO3), pH, EC, Ca, Mg, Na, Cl, B, and whether it uses chlorine or chloramine. Alkalinity above ~100-150 mg/L as CaCO3 pushes root-zone pH up; sodium above ~50 mg/L and chloride above ~70 mg/L are a problem; softened water is high in sodium.
- Measure runoff EC against input EC. Water to 10-20% runoff, collect the runoff in a clean cup and measure EC of both with a calibrated meter (1.413 mS/cm standard). Runoff more than ~0.5 mS/cm above input means salt build-up; well below input means the plant is hungry or you are over-leaching. In hydro, compare reservoir EC with the EC you mixed.
Look for
Unusually dark, glossy, slightly thick leaves compared with the same cultivar..
The full guide: Nitrogen (N) in cannabis: nitrate vs ammonium, deficiency, toxicity and targets
Guidance, not a guarantee. The checker weighs common causes against what you tell it; confirm with the tests before you treat, change one thing at a time and watch the new growth.