GenetixBayEST. 2009
Systems · Advanced · 2 min read

Recirculating deep water culture (RDWC)

RDWC links several DWC sites to a control bucket and circulates the solution with a pump, so one reservoir sets pH, EC and temperature for every plant and a single chiller cools the lot. It adds circulation and plumbing failure modes to DWC's oxygen and temperature risks. Targets match DWC: 18–22 °C, DO above 6 mg/L, pH 5.6–6.0.

Grower practice
Draft: awaiting expert review Updated
VegFlowerRDWC

Being reviewed. Our editors are double-checking a few figures in this article against primary sources. Marked passages may change.

Short answer. RDWC is DWC with the buckets plumbed together and a pump circulating solution through a control bucket. You get one place to measure and correct pH, EC and temperature and one chiller for every plant, plus larger total volume (more stable chemistry). The cost is plumbing: a split fitting, a blocked return or a stopped pump now affects every plant. Targets are the same as DWC: 18–22 °C (64–72 °F), DO > 6 mg/L, pH 5.6–6.0.

How it works

Each site has its own air stones. Solution is pumped from the control bucket into the sites (or the reverse), and returns by gravity through bulkhead fittings near the bottom. Because every site shares water, a root-disease outbreak in one site spreads to all [1].

House position: living reservoir preferred. Bacteria will turn up in any reservoir whatever you do, so you may as well have the good ones: GenetixBay prefers a beneficial-microbe reservoir. A sterile reservoir is a valid choice, but only if you commit to it fully (continuous oxidiser or UV/ozone, clean top-ups, no organics) and never mix the two. It's a personal choice; the half-way house is what fails. See root rot and Pythium for both approaches.

Numbers that matter

Parameter Target Notes
Solution temperature 18–22 °C (64–72 °F) Chiller sized for pump heat + room
DO ≥ 6 mg/L Air in every site, not only the control bucket [2]
pH / EC As DWC
Circulation Turn total volume over ~1–4 times per hourbeing reviewed Too fast heats water; too slow leaves stagnant sites
Control bucket 20–30 % of system volumebeing reviewed Room for probes and top-off
Return plumbing ≥ 25 mm (1 in) for small systems Undersized returns overflow sites

How to run it

  1. Level all sites; test with plain water for 24 h and check every joint before plants go in.
  2. Probes, dosing inlet and top-off live in the control bucket.
  3. Inspect roots in every site weekly; any brown slime means system-wide action.
  4. Refresh on schedule; drain via a pump, not by tipping buckets.

Failure modes

Problem Sign Jardin response [4]
Split line / leak One site's level drops while control bucket holds Per-site level floats flag it; leak pad cuts the pump rail
Circulation pump dead Return flow stops; sites stagnate and warm "Stagnant bucket" alarm; proof-of-life by current
Air failure DO falls in all sites Alert, chiller stays on, backup pump if fitted
Root rot Spreads through system Clean and sterilise between runs; cool water

Jardin notes

Jardin method "RDWC": as DWC plus per-bucket level floats, circulation-pump proof-of-life and a stagnant-bucket alarm. Time-to-harm: 2–12 h for air, days for chemistry. Automation level 3 [4].

Safety

As DWC: GFCI/RCD on every outlet, drip loops, leak trays. RDWC systems hold hundreds of litres; plan for a full spill.

Common mistakes

  • Relying on air only in the control bucket.
  • Undersized return lines.
  • Mixing plants of different vigour on one system (one EC for all).

Evidence

Root-disease spread and DO/temperature behaviour in recirculating hydroponics are Established [1][2][3]. RDWC-specific design numbers are Grower practice.

Questions this article answers

Should my reservoir be sterile or full of beneficial microbes?

RDWC links several DWC sites to a control bucket and circulates the solution with a pump, so one reservoir sets pH, EC and temperature for every plant and a single chiller cools the lot. It adds circulation and plumbing failure modes to DWC's oxygen and temperature risks. Targets match DWC: 18–22 °C, DO above 6 mg/L, pH 5.6–6.0.

What is the difference between DWC and RDWC?

RDWC links several DWC sites to a control bucket and circulates the solution with a pump, so one reservoir sets pH, EC and temperature for every plant and a single chiller cools the lot. It adds circulation and plumbing failure modes to DWC's oxygen and temperature risks. Targets match DWC: 18–22 °C, DO above 6 mg/L, pH 5.6–6.0.

How big should the RDWC control bucket be?

RDWC links several DWC sites to a control bucket and circulates the solution with a pump, so one reservoir sets pH, EC and temperature for every plant and a single chiller cools the lot. It adds circulation and plumbing failure modes to DWC's oxygen and temperature risks. Targets match DWC: 18–22 °C, DO above 6 mg/L, pH 5.6–6.0.

How fast should the RDWC pump circulate?

RDWC links several DWC sites to a control bucket and circulates the solution with a pump, so one reservoir sets pH, EC and temperature for every plant and a single chiller cools the lot. It adds circulation and plumbing failure modes to DWC's oxygen and temperature risks. Targets match DWC: 18–22 °C, DO above 6 mg/L, pH 5.6–6.0.

One plant in my RDWC has root rot; what now?

RDWC links several DWC sites to a control bucket and circulates the solution with a pump, so one reservoir sets pH, EC and temperature for every plant and a single chiller cools the lot. It adds circulation and plumbing failure modes to DWC's oxygen and temperature risks. Targets match DWC: 18–22 °C, DO above 6 mg/L, pH 5.6–6.0.

Sources

  1. Colorado State University Extension PlantTalk 2043. Root disease problems and management in hydroponic systems. planttalk.colostate.edu/topics/miscellaneous/2043-root-disea
  2. Cornell CEA, 2016. Leafy greens (GPN): DO and pH guidance. cea.cals.cornell.edu/files/2019/06/GPNOctober2016_LeafyGreen
  3. Resh HM, 2022. Hydroponic Food Production, 8th ed. CRC Press. doi.org/10.1201/9781003133254
  4. GenetixBay Jardin engineering notes, 2026 (system profiles and failure margins)..

Related

SupportedIntermediate · Draft

Deep water culture (DWC)

In DWC roots hang in an aerated nutrient solution. It grows fast but depends on two things: dissolved oxygen (keep above about 6 mg/L, ideally near saturation) and solution temperature (18–22 °C / 64–72 °F). Warm, poorly aerated water is how Pythium root rot starts. Run pH 5.6–6.0 and EC 0.8–2.0 mS/cm by stage, and treat the air pump as life support.

SupportedAdvanced · Draft

Nutrient film technique (NFT)

In NFT a thin, continuous film of nutrient solution runs down sloped channels past bare roots. It is efficient and well proven for lettuce and herbs, but large cannabis root masses can dam the channel, and roots dry within one to three hours if the pump stops. Keep flow continuous (about 1–2 L/min per channel), slope about 1:30 to 1:100, and solution at 18–22 °C.

Grower practiceBeginner · Draft

Choosing your growing system: soil, coco, rockwool or hydro

Choose by how much attention and measurement you can give, not by yield claims. Soil and living soil forgive mistakes for days; coco and drip need daily feeding; DWC, NFT and aeroponics grow fast but can lose roots within hours if a pump or air supply fails. No controlled study shows one system out-yielding the others when light and climate are equal.

EnvironmentSupportedBeginner · Draft

Temperature by stage: day, night and root-zone targets

Run roughly 24–28 °C (75–82 °F) by day in veg, 22–26 °C (72–79 °F) in flower, cooling to 20–24 °C (68–75 °F) in late flower, with nights 3–6 °C (5–10 °F) cooler. Above about 30 °C (86 °F) photosynthesis in cannabis falls unless light and CO₂ are high. Keep the root zone and hydro reservoirs at 18–22 °C (64–72 °F).

DiseasesEstablishedIntermediate · Draft

Root rot and Pythium in cannabis

Pythium root rot is a water mould that thrives in warm, low-oxygen root zones and swims between plants in recirculating water. Brown, slimy roots whose outer layer slides off, plus wilting with a wet root zone, are the signature. Fix the root-zone conditions first: solution at about 18–21 °C (65–70 °F), high dissolved oxygen, clean water and no overwatering; then remove dead roots and re-establish beneficial microbes.

Was this helpful?

Tell us by joining the waitlist: Founding Members shape what the Professor writes next.

Yes, keep them comingNot quite: I want more
Professor Greenleaf

Grow with the Professor.

The GenetixBay community is coming: honest grow journals, permanent GB-IDs for genetics, and a Professor who answers with citations. Founding Members get first access and the lowest numbers in the archive.

Join the waitlistFund the Bay