GenetixBayEST. 2009
Systems · Beginner · 2 min read

Bottom-watering, soak trays and wick (self-watering) systems

Bottom-watering lets pots draw solution up from a tray, either by a timed soak (flood 2–5 cm for 10–30 minutes, then drain) or by a constant shallow level held by a float valve or wick. It is gentle and labour-saving and suits soil, but salts accumulate at the top of the pot, so feed at lower EC than top-feeding and top-water to runoff every week or two.

Supported
Draft: awaiting expert review Updated
Any stageSoilCocoLiving soil

Being reviewed. Our editors are double-checking a figure in this article against primary sources. Marked passages may change.

Short answer. Pots stand in a tray and drink from below. Two flavours: soak (fill the tray 2–5 cm / 1–2 in for 10–30 min, drain, repeat 1–2× a day as needed) and constant level (a float valve or wick keeps a shallow reservoir topped up) [4]. It's the gentlest method on hardware and roots and suits soil well [4]. The catch: evaporation pulls salts to the top of the pot, where EC can reach several times the rest of the root zone [1][2][3]. Feed weaker than you would top-feed and top-water to runoff every 7–14 days.

Numbers that matter

Parameter Target Notes
Soak depth 2–5 cm (1–2 in) [4]
Soak dwell 15–30 min, then drain [4]
Feed EC ~20–30 % below top-feed equivalent being reviewed
Top-water flush Every 7–14 days, to 10–20 % runoff Pushes the salt layer down and out
Constant-level systems "Dry the tray" day every 7–10 days Re-oxygenates the pot base [4]
Media Soil, airy coco/perlite blends Dense media wick too much, stay soggy

How to run it

  1. Start seedlings top-watered until roots reach the pot bottom; then switch.
  2. Use a free-draining mix with a coarse bottom layer for wick/float systems.
  3. Weigh pots or use a VWC probe to decide soak frequency.
  4. Sample EC from the top layer separately if tips burn; discard the top 1–2 cm when sampling the root zone [3].
  5. Keep trays clean; standing nutrient solution grows algae and fungus gnats.

Failure modes

Problem Sign Response
Salt crust on top White crust, burnt leaf tips Top-water flush; lower EC
Waterlogged base Slow growth, brown bottom roots Dry-tray days; airier mix
Stagnant tray Smell, algae Refresh; Jardin can add an air-stone option [4]
Tray overflow Water on floor Level sensor + leak pad [4]

A warning when switching methods: if you stop bottom-watering and start heavy top-watering, the salt layer moves down into the roots at once [3]. Flush gradually.

Jardin notes

Jardin method "Sub-irrigation / soak / wick": tray level (float or pressure) and reservoir mass required; soak = fill to level, dwell, drain (max-on timer 1.5 × learned fill); wick = continuous hold with periodic dry days. Time-to-harm: days. Automation level 3 [4].

Common mistakes

  • Hydro-strength feed in a wick system.
  • Never top-watering.
  • Bottom-watering seedlings in big pots before roots reach the base.

Evidence

Top-layer salt accumulation and the switching risk are Established extension knowledge [1][2][3]. Cannabis-specific EC reductions are Grower practice.

Questions this article answers

Is bottom watering good for cannabis?

Bottom-watering lets pots draw solution up from a tray, either by a timed soak (flood 2–5 cm for 10–30 minutes, then drain) or by a constant shallow level held by a float valve or wick. It is gentle and labour-saving and suits soil, but salts accumulate at the top of the pot, so feed at lower EC than top-feeding and top-water to runoff every week or two.

Do self-watering pots work for cannabis?

Bottom-watering lets pots draw solution up from a tray, either by a timed soak (flood 2–5 cm for 10–30 minutes, then drain) or by a constant shallow level held by a float valve or wick. It is gentle and labour-saving and suits soil, but salts accumulate at the top of the pot, so feed at lower EC than top-feeding and top-water to runoff every week or two.

Why is there white crust on top of my bottom-watered pots?

Bottom-watering lets pots draw solution up from a tray, either by a timed soak (flood 2–5 cm for 10–30 minutes, then drain) or by a constant shallow level held by a float valve or wick. It is gentle and labour-saving and suits soil, but salts accumulate at the top of the pot, so feed at lower EC than top-feeding and top-water to runoff every week or two.

Should I bottom water seedlings?

Bottom-watering lets pots draw solution up from a tray, either by a timed soak (flood 2–5 cm for 10–30 minutes, then drain) or by a constant shallow level held by a float valve or wick. It is gentle and labour-saving and suits soil, but salts accumulate at the top of the pot, so feed at lower EC than top-feeding and top-water to runoff every week or two.

Sources

  1. UMass Extension. Subirrigation for greenhouse crops. umass.edu/agriculture-food-environment/greenhouse-floricultu
  2. NC State University. Subirrigation (top-layer EC). hortscans.ces.ncsu.edu/uploads/s/u/subirrig_51e435ff2e468.pd
  3. University of Arkansas. Greenhouse management, Unit 9 §6 (salts in the upper inch; risk when switching to overhead watering). greenhouse.hosted.uark.edu/Unit09/Section06.html
  4. GenetixBay Jardin engineering notes, 2026 (system profiles and failure margins)..

Was this helpful?

Tell us by joining the waitlist: Founding Members shape what the Professor writes next.

Professor Greenleaf

Grow with the Professor.

The GenetixBay community is coming: honest grow journals, permanent GB-IDs for genetics, and a Professor who answers with citations. Founding Members get first access and the lowest numbers in the archive.