Nutrients
Every element, deficiencies and toxicities, feed schedules, recipes.
"Bloom boosters" for cannabis: what's real and what's marketing
Most bloom boosters are concentrated phosphorus and potassium. Four independent controlled cannabis trials found no increase in flower yield or cannabinoids from raising phosphorus above roughly 25–60 mg/L, and one found no yield response to potassium anywhere from 60 to 340 mg/L. A complete, balanced flower feed is what matters; extra P and K mostly end up in the runoff and can induce magnesium, calcium, zinc and iron problems. Some boosters have been reported to contain undeclared plant growth regulators, which have no place in a consumable crop.
Boron (B) in cannabis: distorted tips, dying roots and a narrow safe window
Boron cross-links cell-wall pectin and is needed wherever cells are dividing: shoot tips, root tips and flowers. Deficiency in cannabis causes stunted, distorted new growth, dead growing tips and wilting from root-tip death; toxicity scorches the margins of older leaves. Supply about 0.2–0.5 mg/L B; cannabis tolerated a tenfold dose for weeks but the gap between enough and too much is narrower than for most nutrients.
Building a cannabis feed by stage: ppm targets per element and how to hit them
A good mineral cannabis feed runs roughly N 150–200, P 30–60, K 175–250, Ca 150–200, Mg 40–70 and S 60–120 mg/L in veg and flower, plus Fe 1.5–3 and small amounts of Mn, Zn, B, Cu and Mo, at an EC of about 1.2–1.8 mS/cm in veg and 1.6–2.2 in flower. Cannabis research shows no benefit from pushing P or overall strength higher. This article gives the targets, the evidence behind each, and two worked RO-water recipes with a sources table.
Cal-Mag: what it is, when you need it and when you don't
Cal-Mag is a calcium and magnesium supplement, usually calcium nitrate and magnesium nitrate, sometimes with iron. You need it when your water and base nutrient together supply too little Ca and Mg: RO or very soft water, new or unbuffered coco, or a base nutrient designed for hard water. How much a plant needs is driven mainly by its cultivar, the water source, the medium (coco's cation exchange), root-zone pH and transpiration. The claim that LED lights create a Cal-Mag need is a myth. You do not need it on hard tap water with a complete base feed, and overusing it adds nitrogen and pushes potassium and magnesium out of balance.
Calcium (Ca) in cannabis: deficiency, transport, targets and sources
Calcium builds cell walls and membranes and moves only in the transpiration stream, so it cannot be moved from old leaves to new ones. Feed about 150–200 mg/L Ca in soilless systems, and remember that most 'calcium deficiency' is a delivery problem (low transpiration, high humidity, root damage, competing K/Mg/NH4) rather than an empty bottle. Classic signs are distorted, stunted new growth and brown spots.
Chlorine and chloride (Cl) in cannabis: a micronutrient you never need to add
Chloride (Cl-) is an essential micronutrient for water splitting, osmotic balance and stomata, but the requirement is tiny and always met by water and fertiliser impurities. In practice chloride is a salinity problem, not a deficiency: keep it below roughly 50–70 mg/L in the feed, watch it in coco and some tap waters, and don't confuse chloride (a nutrient ion) with chlorine or chloramine (disinfectants).
Copper (Cu) in cannabis: limp, distorted new growth and root-burning excess
Copper is needed for photosynthetic electron transport, lignin and cell-wall strength. Cannabis copper deficiency showed late as stunted, distorted, slightly yellow new leaves that lost turgor and wilted, with a 45% biomass loss. Supply only about 0.03–0.1 mg/L Cu; excess (from copper fungicides, ionisers or pipework) damages roots first.
Flushing before harvest: myth (summary)
Pre-harvest flushing is a myth that costs you yield and resin: it starves the plant while it packs on its final weight, trichomes and resin, and controlled studies found no gain in quality, minerals or cannabinoids. Cannabis stores what it takes up in its tissue, so plain water at the end doesn't wash it out. Feed through to harvest at stage-appropriate strength. The one valid flush treats the medium: a root-zone flush to clear salt build-up, at any stage. Full evidence in the flush debate article.
Hydroponic salts explained: what each fertiliser salt supplies
Almost every mineral cannabis feed is built from about a dozen salts: calcium nitrate, potassium nitrate, monopotassium phosphate (MKP), magnesium sulfate, potassium sulfate, a few others, plus chelated iron and trace salts. Each one supplies known percentages of two elements, so 1 g/L of a salt gives (percent x 10) mg/L of each. Calcium must be kept apart from sulfate and phosphate in concentrated stocks, which is why feeds come as A and B.
Iron (Fe) in cannabis: yellow new growth, chelates and pH
Iron is needed to make chlorophyll and run electron transport. Deficiency shows as interveinal yellowing of the newest leaves and is almost always caused by high root-zone pH or alkaline water, not a lack of iron in the feed. Supply about 1.5–3 mg/L Fe as a chelate matched to your pH: EDTA up to about 6.5, DTPA to about 7.5, EDDHA to about 9.
Magnesium (Mg) in cannabis: interveinal yellowing, targets and the K-Ca competition
Magnesium sits at the centre of chlorophyll. Cannabis trials put the optimum at about 35–70 mg/L Mg in veg, and Mg supply raised cannabinoid and terpene production in flower. Deficiency shows as interveinal yellowing on older leaves with green veins; it is often induced by low pH or by too much potassium or calcium rather than an actual lack of Mg.
Manganese (Mn) in cannabis: netted chlorosis, low-pH toxicity and the iron balance
Manganese is needed to split water in photosynthesis. Deficiency gives a bright yellow, netted interveinal chlorosis on upper and middle leaves with small tan spots; toxicity, usually from low root-zone pH, gives yellowing and necrosis of older leaf margins. Supply about 0.3–0.8 mg/L Mn and keep pH in range, because Mn availability swings strongly with pH.
Mobile vs immobile nutrients: reading old vs new leaves
Mobile nutrients (N, P, K, Mg, and also Cl, Mo, Ni) can be moved from old leaves to new ones through the phloem, so their shortages show on the oldest, lowest leaves first. Immobile nutrients (Ca, B, Fe, Mn, Cu, Zn, and partly S) stay where they were first deposited, so shortages show on new growth. It is the first fork in any deficiency diagnosis, with a few cannabis-specific exceptions.
Molybdenum (Mo) in cannabis: the trace element nitrate depends on
Molybdenum is a cofactor for nitrate reductase, so a nitrate-fed plant cannot use its nitrogen without it. Cannabis needs a minuscule amount (about 0.01–0.05 mg/L Mo); in a 9-week trial, cannabis grown with no Mo showed no visible symptoms at all despite 96% lower leaf Mo. Unlike the other micronutrients, Mo becomes more available as pH rises, so deficiency is a low-pH, acid-soil problem.
Nickel (Ni) in cannabis: essential, needed in traces, almost never worth adding
Nickel became the most recently accepted essential plant micronutrient in 1987; its known job is activating urease, the enzyme that breaks down urea. Requirements are so small that contamination in salts, water and media normally covers them, and there is no published evidence of nickel deficiency in cannabis. Do not add nickel unless you feed urea in a very pure system; excess nickel is toxic and cannabis is known to accumulate metals.
Nitrogen (N) in cannabis: nitrate vs ammonium, deficiency, toxicity and targets
Nitrogen drives leaf growth and photosynthesis. Cannabis does best on mostly nitrate N (about 150–200 mg/L in soilless veg and early flower), with ammonium kept at or below about 10–30% of total N; above 30% ammonium, cannabis trials show toxicity and lost yield. Deficiency yellows the oldest leaves first; excess gives dark, clawed leaves and soft, leafy growth.
Nutrient antagonism and Mulder's chart: what the evidence actually says
Mulder's chart is a mid-20th-century wheel of nutrient interactions. It is a useful reminder that excess of one nutrient can suppress another, but it is a teaching sketch, not a quantitative tool. A review of 117 published interactions found synergy far more often than antagonism; the antagonisms that reliably matter in practice are among cations (K, Ca, Mg, NH4, Na), phosphorus with zinc and iron, and iron with manganese.
Organic vs mineral nutrition for cannabis: what the trials show
Plants absorb the same ions whether they came from a bag of salts or from compost; the differences are in speed, precision and what else comes along. Controlled cannabis trials show mineral feeds deliver nutrients more efficiently and organic liquid feeds need higher nominal N to match them. Organic and lower-input regimes can keep cannabinoid content per gram up while yield falls. Plants mostly don't care where the ions come from; slight differences in flavonoids or terpenes are possible but unproven, and no controlled blind trial shows organic flower tastes better.
Per-element feeding tricks: what growers adjust, stage by stage
Experienced growers change single elements by stage rather than just turning the whole feed up or down: tapering nitrogen in late flower, cutting the ammonium share after the flip, a little extra calcium through the stretch, small magnesium, boron and zinc bumps in flower, silicon in veg. Most of these tricks are grower practice with little or no controlled research behind them. Two popular ones are contradicted by research: extra phosphorus above about 30–60 mg/L and potassium 'ramps' above about 250 mg/L did not raise yield or cannabinoids in controlled cannabis trials. Sugars and molasses feed soil microbes only, not the plant, and do harm in hydro. The GenetixBay approach is to taper nitrogen and keep everything else fed, which needs single salts or per-element dosing.
Phosphorus (P) in cannabis: what it does, deficiency, excess and how much is enough
Phosphorus powers energy transfer (ATP), roots and flowering, but cannabis needs far less than 'bloom' marketing implies. Controlled trials found no yield or cannabinoid gain above roughly 25–60 mg/L P in solution; extra P just ends up in the runoff and can tie up zinc, iron and calcium. Deficiency shows as dark, dull, olive-spotted older leaves and stunting.
Potassium (K) in cannabis: role, deficiency, excess and K-Ca-Mg balance
Potassium runs water relations, stomata and sugar transport. Cannabis grows well on roughly 175–240 mg/L K in veg, and a flowering DWC trial found no yield response anywhere between 60 and 340 mg/L K, so more is not better. Deficiency scorches the margins and serrations of older leaves; excess K mainly does harm by suppressing calcium and magnesium uptake.
Silicon (Si) for cannabis: beneficial, not essential, and how to dose it
Silicon is a beneficial element, not an essential one. It strengthens cell walls and reduces abiotic and some disease stress in many crops, and cannabis does take it up, but cannabis-specific evidence for yield or quality benefits is thin. If you use it, add potassium silicate first to the water at about 20–50 mg/L Si, before other nutrients, and correct pH afterwards because it is strongly alkaline.
Sodium (Na) and cannabis: a salt to keep low, not a nutrient to add
Sodium is not essential for cannabis. It can partly substitute for potassium in some plants, but in cannabis the controlled data show only harm: cannabinoids fall linearly as NaCl rises, and more than about 5 mM NaCl (115 mg/L Na) may reduce yield in hydro. Keep sodium below about 50 mg/L in the feed, never use ion-exchange softened water, and watch it build up in coco and recirculating systems.
Sulfur (S) in cannabis: role, deficiency, targets and sulfate sources
Sulfur is part of the amino acids cysteine and methionine and of glutathione; cannabis also makes sulfur-containing aroma compounds. Feeds usually supply 50–120 mg/L S as sulfate without trying, via magnesium and potassium sulfate. Deficiency yellows the middle and newer leaves evenly, strongest at the leaflet base, and is rare unless a feed is built entirely from nitrates and chlorides.
Zinc (Zn) in cannabis: small leaves, margin burn and the phosphorus link
Zinc is needed for many enzymes and for making the growth hormone auxin. Deficiency in cannabis shows late, as yellowing and then tan necrosis along the toothed margins of new leaves, often with small leaves and short internodes elsewhere in the literature. Supply about 0.1–0.5 mg/L Zn; high pH and very high phosphorus are the usual reasons a fed plant runs short.
