# Pistils browning early in flower: likely causes and fixes

> Pistils browning early in flower on cannabis is most often Heat stress, Heat or light stress foxtailing on the top colas or Light bleaching at the canopy top. How to tell them apart, the fix for each and what recovery looks like.

Also called: hairs turning brown early, pistils browning, red hairs early, orange hairs week 3.

Run the checker with this sign: https://genetixbay.com/knowledge/diagnose/?at=buds&s=pistils-brown-early

## Likely causes, most likely first

### Heat stress (Possible)

- Kind: Environment; urgency: Act within a day or two
- Fix: Bring canopy leaf temperature under about 30 °C (86 °F): more exhaust (one tent air exchange every 1-3 minutes), raise or dim the light, add canopy airflow (0.3-1.0 m/s), keep RH so VPD stays 1.0-1.5 kPa, water well. Above ~30 °C photosynthesis falls unless CO2 and light are high.
- Recovery: Leaves flatten within a day; no new foxtails or crisping.
- Confirm: IR leaf temperature at the canopy top: Point an IR thermometer at the top leaves under the light (5-10 cm away, emissivity 0.95) and at shaded leaves. Leaf temperature above about 30 °C (86 °F) at the top only points to heat or radiant load; leaf VPD can be calculated from leaf temperature and RH.
- Confirm: Check temperature and RH at canopy height with a calibrated sensor: Put a calibrated sensor (salt test: a sealed bag with damp table salt reads 75% RH after 8-12 hours) at canopy height, out of direct light, and log for 24 hours including lights-off. Look for lights-off RH spikes and dew point.
- Article: [Heat and light stress: taco leaves, bleaching and foxtails](https://genetixbay.com/knowledge/environment/heat-light-stress.md)

### Heat or light stress foxtailing on the top colas (Less likely)

- Kind: Light; urgency: Low urgency
- Fix: Lower top-cola PPFD and leaf temperature (leaf under ~28-30 °C / 82-86 °F); even out the canopy. Evidence is mostly grower observation.
- Recovery: No new spires on top colas over the next week.
- Confirm: Measure PPFD at the canopy top: Use a quantum (PAR) meter, or a calibrated phone app as a rough guide, at the top leaves in a 5-9 point grid. Compare with the stage target: seedlings 100-300, veg 300-700, flower 800-1,200 µmol/m²/s at ambient CO2. Bleaching and taco at the top above ~1,100 point to light; stretch below ~300 in veg points to too little.
- Confirm: IR leaf temperature at the canopy top: Point an IR thermometer at the top leaves under the light (5-10 cm away, emissivity 0.95) and at shaded leaves. Leaf temperature above about 30 °C (86 °F) at the top only points to heat or radiant load; leaf VPD can be calculated from leaf temperature and RH.
- Confirm: Compare with siblings or the same cut: Put the affected plant beside siblings or clones of the same cut in the same conditions. A trait shared by all of a cultivar (purple stems, foxtailing, pale colour) is genetic; a problem on one plant points to its roots, a virus or its genetics; a problem on every cultivar points to the environment or feed.
- Article: [Foxtailing buds on cannabis: genetics or stress?](https://genetixbay.com/knowledge/diagnosis/foxtails.md)

### Light bleaching at the canopy top (Less likely)

- Kind: Light; urgency: Deal with it this week
- Fix: Raise or dim the light by 10-20% so top-canopy PPFD sits around 800-1,100 µmol/m²/s at ambient CO2 (up to ~1,500 with CO2 and good climate). Keep the canopy even so one cola doesn't sit in a hotspot. Bleached tissue won't re-green.
- Recovery: No new bleaching within 3-5 days; new bracts and leaves at the top stay green.
- Confirm: Measure PPFD at the canopy top: Use a quantum (PAR) meter, or a calibrated phone app as a rough guide, at the top leaves in a 5-9 point grid. Compare with the stage target: seedlings 100-300, veg 300-700, flower 800-1,200 µmol/m²/s at ambient CO2. Bleaching and taco at the top above ~1,100 point to light; stretch below ~300 in veg points to too little.
- Confirm: IR leaf temperature at the canopy top: Point an IR thermometer at the top leaves under the light (5-10 cm away, emissivity 0.95) and at shaded leaves. Leaf temperature above about 30 °C (86 °F) at the top only points to heat or radiant load; leaf VPD can be calculated from leaf temperature and RH.
- Article: [Heat and light stress: taco leaves, bleaching and foxtails](https://genetixbay.com/knowledge/environment/heat-light-stress.md)

### Light burn: too much light for the plant's climate and CO2 (Less likely)

- Kind: Light; urgency: Deal with it this week
- Fix: Dim or raise the light 10-20%; ramp intensity over 7-10 days after a light change. Seedlings and clones need only 100-300 µmol/m²/s. High PPFD works only with leaf temperature, VPD, roots and feed all in range.
- Recovery: Top leaves flatten within 1-3 days.
- Confirm: Measure PPFD at the canopy top: Use a quantum (PAR) meter, or a calibrated phone app as a rough guide, at the top leaves in a 5-9 point grid. Compare with the stage target: seedlings 100-300, veg 300-700, flower 800-1,200 µmol/m²/s at ambient CO2. Bleaching and taco at the top above ~1,100 point to light; stretch below ~300 in veg points to too little.
- Confirm: IR leaf temperature at the canopy top: Point an IR thermometer at the top leaves under the light (5-10 cm away, emissivity 0.95) and at shaded leaves. Leaf temperature above about 30 °C (86 °F) at the top only points to heat or radiant load; leaf VPD can be calculated from leaf temperature and RH.
- Article: [Heat and light stress: taco leaves, bleaching and foxtails](https://genetixbay.com/knowledge/environment/heat-light-stress.md)

## Note

Guidance, not a guarantee. The checker weighs common causes against what you tell it; confirm with the tests before you treat, change one thing at a time and watch the new growth.