# Do I need an intake fan or is passive intake enough?

> Passive intake is enough for most grow tents: an exhaust fan pulls air out and low, open intake ports let fresh air in, keeping the tent under slight negative pressure so smell can't escape. Make the open intake area about 2–3 times the exhaust duct area. Add an intake fan only for big rooms or long intake runs, and keep it weaker than the exhaust.

- Canonical: https://genetixbay.com/knowledge/answers/do-i-need-an-intake-fan.html
- Topic: Environment · Type: How-to
- Evidence: Grower practice · Status: Draft: awaiting expert review
- Full article: [Airflow: air exchange, canopy air speed and fan placement](https://genetixbay.com/knowledge/environment/airflow.md)
- Also asked as: Is passive intake enough for a grow tent? | How do I get negative pressure in a tent? | Do I need an intake fan? | Tent walls sucking in too much
- Updated: 2026-10-31 · Licence: CC BY-SA 4.0 (https://creativecommons.org/licenses/by-sa/4.0/), attribute "GenetixBay Knowledge Base (genetixbay.com/knowledge)"

## Short answer

Passive intake is enough for most grow tents. The [exhaust fan](https://genetixbay.com/knowledge/glossary/exhaust-fan.md) pulls air out through the [carbon filter](https://genetixbay.com/knowledge/glossary/carbon-filter.md), and low open ports let fresh air in. Give the intake about **2–3 times the open area of the exhaust duct**. Add an intake fan only for large rooms or long intake runs, and always keep it **weaker than the exhaust**. *Grower practice*.

## Why

The exhaust's job is to remove heat and humidity, typically one full tent volume every 1–3 minutes in a lit tent. Stagnant, hot, humid air raises [leaf temperature](https://genetixbay.com/knowledge/glossary/leaf-temperature.md) [1] and invites mould [2].

Air has to come in as fast as it leaves. With passive intake the fan creates slight [negative pressure](https://genetixbay.com/knowledge/glossary/negative-pressure.md), which draws air through the ports. That same pressure keeps smell inside: every leak flows inwards.

An intake fan stronger than the exhaust flips this. The tent goes positive, walls bulge, and unfiltered air escapes through zips and seams.

Intake ports too small make the fan work against a vacuum, so real airflow drops and the tent runs hot.

## The numbers

| Item | Target |
|---|---|
| Exhaust, lit tent (no CO₂) | 1 full volume every 1–3 minutes |
| Filter and ducting allowance | +25–50 % fan capacity |
| Passive intake open area | ≈ 2–3 × exhaust duct area |
| Intake position | low, opposite side from the exhaust |
| Intake fan, if used | lower airflow than the exhaust |
| Walls | bowing gently inwards |

## What to do

1. Put the exhaust and filter high; open intake ports low on the far side.
2. Start with intake area about 2–3 times the exhaust duct area.
3. Watch the walls: gentle inward bow is right.
4. Walls sucking in hard? Open another port.
5. Tent still hot with the fan at full speed? Check the room temperature before buying an intake fan.
6. If you add an intake fan, run it slower than the exhaust and screen it against pests.

## Common mistakes

- An intake fan stronger than the exhaust, pushing smell out.
- Intake ports high, next to the exhaust, so fresh air short-circuits out.
- Too little intake, starving the fan.
- Unscreened intakes in summer, pulling in pests.

## Related

- Full article: [Airflow](https://genetixbay.com/knowledge/environment/airflow.md)
- Guide: [Smell control basics](https://genetixbay.com/knowledge/guides/smell-control-basics.md)
- [How do I stop my grow tent from smelling?](https://genetixbay.com/knowledge/answers/how-to-control-grow-smell.md)
- [Should my exhaust fan run 24/7?](https://genetixbay.com/knowledge/answers/run-exhaust-fan-24-7.md)
- Terms: [negative pressure](https://genetixbay.com/knowledge/glossary/negative-pressure.md) · [exhaust fan](https://genetixbay.com/knowledge/glossary/exhaust-fan.md)

## Follow-up questions

**How big should passive intake be?** Passive intake for a grow tent should have about 2–3 times the open area of the exhaust duct, placed low on the opposite side from the exhaust. With a 150 mm (6 in) exhaust, that means two or three open ports of similar size. Too little intake makes the walls suck in hard and starves the fan; too much, and the walls stop drawing in at all.

**Should my tent walls bow in?** Yes, a grow tent's walls should bow gently inwards with the exhaust running. That shows negative pressure: the fan removes air faster than it leaks in, so gaps and zips leak clean room air in rather than smelly air out. If the walls suck in hard and flap, open another low intake; if they are flat or bulge, raise the fan speed or seal leaks.

**When do I need an intake fan?** You need an intake fan when passive ports can't supply enough air: large rooms, intake air ducted from another room or outdoors, or long duct runs with bends. Run the intake fan at a lower airflow than the exhaust so the space stays under negative pressure. Screen or filter the intake, because it can pull in pests and dust.

## Sources

1. Nelson JA, Bugbee B, 2015. Analysis of environmental effects on leaf temperature under sunlight, HPS and LEDs. PLoS ONE 10(10): e0138930. https://pmc.ncbi.nlm.nih.gov/articles/PMC4598144/
2. Punja ZK, 2021. Emerging diseases of Cannabis sativa and sustainable management. Pest Management Science 77:3857–3870. https://pmc.ncbi.nlm.nih.gov/articles/PMC8451794/