# Can I mix soil and coco?

> Yes, you can mix soil and coco: adding buffered coco to potting mix lightens it, holds water well and stays airy. Decide which system the blend behaves like. Mostly soil (coco 50% or less): water at pH 6.2–6.8 and feed at soil strength. Mostly coco: run pH 5.8–6.2 and feed every watering. Use washed, buffered coco or it will grab calcium and magnesium.

- Canonical: https://genetixbay.com/knowledge/answers/can-i-mix-soil-and-coco.html
- Topic: Systems · Type: How-to
- Evidence: Grower practice · Status: Draft: awaiting expert review
- Full article: [Growing in coco coir](https://genetixbay.com/knowledge/systems/coco.md)
- Also asked as: Can I mix coco into potting soil? | Is a 50/50 coco soil mix good? | Soil and coco mix for cannabis | Do I feed a coco soil mix like soil or coco?
- Updated: 2026-10-31 · Licence: CC BY-SA 4.0 (https://creativecommons.org/licenses/by-sa/4.0/), attribute "GenetixBay Knowledge Base (genetixbay.com/knowledge)"

## Short answer

Yes, you can mix soil and [coco](https://genetixbay.com/knowledge/glossary/coco-coir.md). Buffered coco lightens a heavy [potting mix](https://genetixbay.com/knowledge/glossary/potting-mix.md) and holds water and air at the same time. Decide which system the blend behaves like: mostly soil, water at [pH](https://genetixbay.com/knowledge/glossary/ph.md) 6.2–6.8 and feed at soil strength; mostly coco, run pH 5.8–6.2 and feed every watering. *Grower practice*; the coir chemistry behind it is established.

## Why

Coir pith is a [peat](https://genetixbay.com/knowledge/glossary/peat.md) substitute with good water holding and [air space](https://genetixbay.com/knowledge/glossary/air-filled-porosity.md), and it has been used in commercial potting mixes for decades [1].

Raw coir carries potassium and [sodium](https://genetixbay.com/knowledge/glossary/sodium.md) from the husk and has modest [exchange capacity](https://genetixbay.com/knowledge/glossary/cation-exchange-capacity.md) [1]. Feed it calcium and it swaps calcium onto its sites and releases potassium, so unbuffered coco shows early calcium and magnesium shortages. Washed, buffered coco avoids this [2].

The two media feed differently. Potting mix brings compost and a starter charge and buffers pH. Coco brings no nutrients and buffers pH weakly. A blend sits between the two, and the larger share sets the rules.

Organic feeding works in coir blends too, once nitrogen supply is adequate [3].

## The numbers

| Blend (coco share) | Behaves like | Irrigation pH | Feeding |
|---|---|---|---|
| 10–30% | Soil | 6.2–6.8 | Starter charge, then soil strength, [EC](https://genetixbay.com/knowledge/glossary/ec.md) 0.8–1.6 [mS/cm](https://genetixbay.com/knowledge/glossary/ms-cm.md) |
| 40–50% | Mostly soil | 6.2–6.5 | Starter charge, then feed every second watering |
| 60% and up | Coco | 5.8–6.2 | Full mineral feed every watering, EC 1.2–2.4, 10–20% [runoff](https://genetixbay.com/knowledge/glossary/runoff.md) |

Add 20–30% [perlite](https://genetixbay.com/knowledge/glossary/perlite.md) through any blend that will be hand-watered.

## What to do

1. Use washed, buffered coco, or rinse to runoff EC below about 0.5 mS/cm and buffer it.
2. Pick your blend and decide up front whether you'll run it as soil or as coco.
3. Mix evenly and add perlite through the whole pot.
4. Check runoff pH and EC a few times in the first three weeks.
5. Adjust: if lower leaves pale early, the starter charge was diluted, so start feeding sooner.

## Common mistakes

- Raw, unbuffered coco, then blaming the lights for calcium spots (that's a *Myth*; coco, [RO water](https://genetixbay.com/knowledge/glossary/ro-water.md) and the cultivar drive it).
- Running a mostly-coco blend like soil, with plain-water days.
- Assuming the blend still has a full starter charge after diluting the soil by half.

## Related

- Full article: [Growing in coco coir](https://genetixbay.com/knowledge/systems/coco.md)
- Answers: [coco to perlite ratio](https://genetixbay.com/knowledge/answers/coco-perlite-ratio.md) · [best soil for cannabis](https://genetixbay.com/knowledge/answers/best-soil-for-cannabis.md)
- Systems: [growing in soil](https://genetixbay.com/knowledge/systems/soil.md)
- Terms: [coco coir](https://genetixbay.com/knowledge/glossary/coco-coir.md) · [potting mix](https://genetixbay.com/knowledge/glossary/potting-mix.md)

## Follow-up questions

**Should I pH a coco soil mix like soil or coco?** Run a coco soil mix at the pH of whichever part dominates. A blend that is half or more potting mix keeps soil's buffering and does well at pH 6.2–6.8. A blend that is mostly coco behaves like hydroponics in a pot and wants pH 5.8–6.2. Check runoff pH a few times in the first weeks to see what the root zone is doing.

**Does coco in soil cause calcium deficiency?** Coco mixed into soil can cause calcium and magnesium shortages if the coco is raw and unbuffered. Raw coir is loaded with potassium and sodium and pulls calcium and magnesium from the feed onto its exchange sites. Use coco sold as washed and buffered, or rinse and buffer it yourself, and the compost in the soil part supplies some extra calcium.

**Is coco better than perlite for lightening soil?** Coco and perlite do different jobs in soil. Coco lightens heavy mixes and holds water and air at once, but it decomposes slowly and has some exchange capacity. Perlite adds air only and holds little water. Many growers use both: buffered coco to replace part of the peat, and 20–30% perlite through the whole mix for drainage.

## Sources

1. Abad M, Noguera P, Puchades R, Maquieira A, Noguera V, 2002. Physico-chemical and chemical properties of some coconut coir dusts for use as a peat substitute for containerised ornamental plants. Bioresource Technology 82(3):241–245. https://doi.org/10.1016/S0960-8524(01)00189-4
2. Greenhouse Grower, 2023. Washed, low-EC, or buffered? How to specify coco substrate for your crop. https://www.greenhousegrower.com/?p=180860
3. Caplan D, Dixon M, Zheng Y, 2017. Optimal rate of organic fertilizer during the vegetative-stage for cannabis grown in two coir-based substrates. HortScience 52(9):1307–1312. https://doi.org/10.21273/HORTSCI12401-17